Futaba changes timing if you run 12 channel on your trainer port. If you having trouble with your Futaba remote please follow this steps:
- Make sure your TBS Crossfire software version is V1.06 or newer
- Go to your Futaba trainer port settings ( SYS -> Trainer -> Page 4/4 ) and make sure CH MODE is set to 12CH.
- Watch your TBS Crossfire TX display for a while and make sure the status on RC input is solid to FUT 12Ch.
If the RC input status is not solid to the same value please update your remote and check the cable connection between the remote and the TBS Crossfire.
Kown RC's with 12 channel PPM out issue:
- T14SG Software version 5.0
Updates for futaba can be found here: