General

Micro TX Bundle Setup Guide
There is a great video showing you how you get started with the TBS CROSSFIRE. https://www.youtube.com/watch?v=38n1zEOXeT0
Fri, 22 Sep, 2017 at 6:27 PM
12 Channel mode with Futaba
Futaba changes timing if you run 12 channel on your trainer port. If you having trouble with your Futaba remote please follow this steps: - Make sur...
Mon, 8 Feb, 2016 at 4:31 PM
How many people can fly if they are all using TBS crossfires?
No upper limits according to our tests. Pilots should turn off telemetry if racing close to each other. interference should not be a big issue as the cross...
Sat, 24 Dec, 2016 at 10:15 AM
Poor Crossfire Range
If you experiencing unexpected bad range of your TBS CROSSFIRE there are a few things you can test. Please start from top of this solution. Quick ste...
Mon, 19 Jun, 2017 at 11:16 PM
Antenna orientation
Basics: TBS CROSSFIRE antenna positioning To get the maximum out of your TBS CROSSFIRE long range system ist important that you mount your antennas pr...
Fri, 27 Oct, 2017 at 12:13 AM
Constantly telemetry warning using FrSky X7
The current hardware revision of FrSky X7 is not fully compatible with the TBS CROSSFIRE CRSF protocol. The symptoms are a constant telemetry warning. Curre...
Fri, 22 Sep, 2017 at 8:05 PM
What is the difference between TBS CROSSFIRE MICRO RECEIVER V1 and V2
TBS CROSSFIRE MICRO RECEIVER V1: - 1 output channel - Output mapping options: PPM, SBUS and CRSF (RC only, no telemetry) - BST telemetry support (TBS GPS...
Wed, 15 Feb, 2017 at 10:55 PM
My Crossfire Micro receiver is flashing green quickly and won't bind
The crossfire micro receiver must have encountered some problems flashing the firmware. It is now in a bootloader mode.  To get it out, you will need ei...
Wed, 28 Dec, 2016 at 3:49 PM
How well does the crossfire deal with interference?
If you have electronic devices or appliances that broadcast on the 800-900mHz band 24/7 you can continue to use the TBS Crossfire as interference should not...
Sat, 24 Dec, 2016 at 10:18 AM
TBS PowerCube Elite Bundle, none of the motors will spin
There are 4 signal pins that line up from the flight controller (top PCB) to the PDB (middle PDB). They transfer the signal from the FC via the PDB to the s...
Wed, 28 Dec, 2016 at 4:40 PM